Dynamic Host Configuration Protocol - Wikipedia

DD-WRT Forum :: View topic - DHCP Forwarder Sep 02, 2006 Configure CentOS 6 Network Settings - Serverlab Jan 21, 2014

Configuring the DHCP Server Settings – AmpliFi

Jan 21, 2014 Network - Configuration | Server documentation | Ubuntu Modify the IP address and subnet mask to match your network requirements. sudo ip addr add 10.102.66.200/24 dev enp0s25 The ip can then be used to set the link up or down. ip link set dev enp0s25 up ip link set dev enp0s25 down To verify the IP address configuration of enp0s25, you can use the ip command in the following manner.

Restart the DHCP Server service. To activate new security group memberships on the DHCP server, you must restart the DHCP Server service. To restart the DHCP Server service. In the Server Manager navigation pane, click DHCP. Under SERVICES, right-click the name of the managed DHCP server, and then click Restart Services.

Navigate to Configuration > Appliance Settings > Network Adapters. In the Network Adapters page, look for the Management Interface DHCP Server pane. Click Enable DHCP Server to start the server, then enter the Lease Time (in minutes), the Domain Name, and define the IP Address range by entering a Start IP Address and an End IP Address. Note Network > DHCP Dynamic Host Configuration Protocol (DHCP) is a standardized protocol that provides TCP/IP and link-layer configuration parameters and network addresses to dynamically configured hosts on a TCP/IP network. An interface on a Palo Alto Networks firewall can act as a DHCP server, client, or relay agent.